ATEIS Middle East Training Agenda
To Register, please download the application Form 
and Email it to haider@ateis.ae
DAY 1
PAVA overview and System Design
The training will start by an introduction to system architecture, solutions and design alternatives according to the following schedule:
9:00 am - 1:00 pm
- Background & Definition PA, VA, Pro-Audio...etc.
- Presentation & overview of products range.
- Special aspect for distributed PAVA.
- Design examples.
1:00 pm - 2:00 pm
2:00 pm - 5:00 pm
- Battery Calculation
- Case Studies:
- Mall Application
- High Rise Towers
- Hotels
- University
- Q & A and Open Discussion
DAY 2
Configuration & Commissioning of PAVA
The training consists of SINAP IDA Configuration.
9:00 am - 1:00 pm
- Background & Definition and Tip of the day (Amplifiers classes, dB, Wattage, Sensitivity...etc.).
- Wiring Diagram.
- Step-by-Step configuration on Demo rack (IDA4M).
- Differences among IDA4SW & IDA4M in configuration.
1:00 pm - 2:00 pm
2:00 pm - 5:00 pm
- IDA in Class AB configuration
- Virtual IDA concept
- Fault management and Review of IDA Error Messages.
- Q & A
DAY 3
Configuration & Commissioning of PA-BGM
The training consists of LAP/UAP IDA Configuration.
9:00 am - 1:00 pm
- Background & Definition and Tip of the day (Signals Level / Audio Cable types, Microphone types, Feed-Back, Filters...etc.)
- LAP / UAP configuration concept.
- Creating somple LAP configuration. testing different DSP blocks and designing customized GUI.
1:00 pm - 2:00 pm
2:00 pm - 5:00 pm
- Adding Remote Controls (RAC & URC) to LAP Configuration.
- Adding PPM to LAP Configuration.
- Adding Pro-Audio MIC to LAP.
- NET Fault Diagnostics.
- Q & A
DAY 4
Line Array Speakers Acoustic Solution & Miscellaneous Tips
A demonstration on Messenger Line Array concept & Lobe design and doing some acoustic measurement by using Handheld NTI meters.
9:00 am - 1:00 pm
- Background & Definition and Tip of the day (Standards, background, Directivity, Speaker looses...etc.)
- Presentation of Line Array Speaker solution.
- Design Different Lobe and download into a live Line Array speaker.
- Use NTI measurement/tools to Verify Lobe design.
1:00 pm - 2:00 pm
2:00 pm - 5:00 pm
- Using NTI devices to:
- Measure SPL, RaSTI, Polarity...etc.
- Tuning and Flat Response
- Feed back killing, cable testing...etc.
- Q & A
